SX3 Pre-Built EPP 3D Aerobatic RC Airplane Incl Motor, ESC, Servos, Li Polys & More

Flying indoors has never been easier. This SX3 ships completely assembled the wing is mounted, servos are installed, control surfaces are hinged, and the linkages are complete. First, install the receiver, ESC, motor, and battery. Then go flying! Our Pre-Built SX3's are made of the highest quality EPP foam. It is considerably lighter and more resistant to tearing than other EPP foams. You will feel the difference. This SX3 design is highly refined. It utilizes fiber tape where testing has shown it is needed; flat carbon fiber in the ailerons, horizontal stabilizer, elevator, and rudder; and a clear tape-sheeted fuselage crossmember. Internal access is a breeze. The bottom of the fuselage is held together with high-quality velcro from the rear of the wing through to the front of the fuselage. This allows unrestricted access to the motor, receiver and ESC. The top of the fuselage has a 5" length of velcro to allow access to the aileron servo and. For long life, the fuselage is held to gether with extra tape where the velcro ends. The SX3 is designed to fly beautifully. It is stable in forward flight, and doesn't all-too-readily fall into steep alpha flight like most flat foam airplanes. Extreme fuselage side and rudder area make the SX3 very comfortable in knife edge. Specifications: * Wingspan: 32.5" / 82.5cm * Length: 35" / 89cm * Wing area: 250 in^2 / 16.5 dm^2 * Weight: 8oz (226g) * High quality EPP Foam Construction * Three installed 6 gram Servos * Hacker A20-34S motor * 2 Thunder Power Pro Lite 2s730 Batteries * Hacker X-7 Pro ESC* Berg 4L receiver Includes * Three installed 6 gram Servos (linkages complete) * Hacker A20-34S (motor) * (2x) Thunder Power Pro Lite 2s730 (two batteries) * Hacker X-7 Pro ESC * Berg 4L (receiver) Required to fly: *Micro Receiver and Transmitter